! ! Increase the size and change the position of the plot on the ! viewport. ! *vpXF : 0.05 *vpYF : 0.90 *vpWidthF : 0.75 *vpHeightF : 0.75 ! ! Fill contours, turn off high, low, and informational labels, ! turn off drawing of contour lines, and set levels to 0.10. ! *cnFillOn : True *cnHighLabelsOn : False *cnLowLabelsOn : False *cnInfoLabelOn : False *cnLineLabelsOn : False *cnLevelSpacingF : 0.10 ! ! Create a stereographic map with an elliptical boundary and change ! the center of the projection. ! *mpProjection : Stereographic *mpEllipticalBoundary : True *mpCenterLatF : -90. ! ! Limit the map view to a smaller area. ! *mpLimitMode : Angles *mpBottomAngleF : 65. *mpLeftAngleF : 65. *mpRightAngleF : 65. *mpTopAngleF : 65. ! ! Turn on map fill and fill land in gray and leave oceans and inland ! water transparent. Make the outlines gray and double their thickness ! *mpFillOn : True *mpGeophysicalLineColor : gray *mpLandFillColor : gray *mpInlandWaterFillColor : transparent *mpOceanFillColor : transparent *mpGeophysicalLineThicknessF : 2. ! ! Don't draw the lat/lon grid lines over land, draw them 45 degrees ! apart, and draw them before the contours. Turn on the drawing of ! a map perimeter. ! *mpGridMaskMode : MaskNotOcean *mpGridSpacingF : 45. *mpGridAndLimbDrawOrder : Predraw *mpPerimOn : True ! ! If you just set *pmLabelBarDisplayMode to True, then a label bar ! for *both* the contour plot and the map would be drawn. So, only ! turn on the label bar for the contour plot. Turning off the label ! bar for the map plot is not necessary since that's the default. ! *contour*pmLabelBarDisplayMode : Always *map*pmLabelBarDisplayMode : Never ! ! Increase the label bar width and height, turn off its perimeter, ! and change the label bar label font to Times-Roman. ! *pmLabelBarWidthF : 0.07 *pmLabelBarHeightF : 0.65 *lbPerimOn : False ! ! Change the height of the main title. ! *tiMainFontHeightF : 0.027